How to improve the welding efficiency of spot welding machine?

How to improve the welding efficiency of spot welding machine ? First of all, it is very important to choose a good welding equipment, and secondly, it is necessary to equip it manually. It is mainly through the following three aspects to train employees to improve. They are footwork, technique and eyesight.

1. foot method

goal: stepping on the foot pedal can skillfully control the welding head to move up, down, pause and afterburner at various speeds.

Exercise Method:

1. Place the wire directly under the welding head, control the welding head to move from top to bottom, stop after the end, just press the wire without triggering, and practice from the slowest to the fastest.

2. Press and hold the above method to practice. The welding head will stop after pressing the line, and then apply force to the welding head to trigger ignition. After proficiency, repeated practice of pressing the line and afterburning welding is very smooth.

3. Use a warped thread end and practice pressing the warped thread end on the pad with a welding head.

2. Technique

Objective: Both hands can move the control product very dexterously.

Exercise Method:

1. Lean your elbow on the table, keep your palms naturally raised, and quickly move the product under the welding head and practice quickly removing the product at the same time by bending your index fingers and swinging your palms. It can move quickly when the platform is not close to the welding head, and slow down when it reaches the bottom of the welding head to match the alignment position.

2. If you hold an auxiliary stick or clip in your right hand, when moving the product, pass the auxiliary stick through the thumb and index finger, as well as between the middle finger and ring finger. When using the product, quickly change the jump position of the middle finger to pass through the thumb and index finger, index finger and middle finger.

3. According to the size of the product, you can put your palm on the platform according to your personal comfort level, and you can move the product quickly through the operation of your index finger.

3. Eyesight

Goal: Accurately judge whether the wire is correctly pressed on the pad, and accurately remember the landing point of the welding head.

Practice Method:

1. Observe the position of the lowest placement point of the solder joint on the screen, remember the position, move the solder joint of the product to the position, practice the operation of the hand on the platform, look at the screen when moving, and look at the product platform when holding the product.

2. Understand the visual difference between the front and back of the welding head. The line should pass through the middle of the bottom of the welding head. What you see on the screen seems to be the line passing behind the welding head.

3. Slowly put the head close to the welding head and observe, align the line through the middle of the bottom of the welding head, don't move after pressing the line with your foot, look up at the display, remember the position where the line on the screen passes through the middle of the bottom of the welding head, remember this scene in your mind, and align the line according to this situation in the future.