How to Install Gantry Precision Energy Storage Spot Welding Machine Correctly

How to correctly install gantry type precision energy storage spot welding machine

Sturt technology precision energy storage series spot welding machine is the current advanced level of high-performance energy storage spot welding machine, using high-performance CPU control, imported IGBT discharge control module, imported film capacitor, blue LCD large LCD screen display, small welding spatter, stable and reliable performance. It has 10 sets of welding parameters for switching function, and at the same time has the welding current monitoring function, which can implement the welding quality to ensure the welding quality. Precautions for installation of

energy storage spot welding machine equipment:

. The installation of spot welding machine should be more than 2000mm away from the wall to prevent accidents caused by overheating.

2, spot welding machine should be installed as far as possible near the transformer room, less wet dust, no harmful gas, flat and solid concrete ground, strong with anchor bolts, and horizontal calibration. Calibration shall be carried out by a mechanical specialist.

3, in order to ensure the safety of personnel and equipment, be sure to make grounding device. The specific requirements are as follows: the grounding wire shall be ≥ 16mm2 multi-strand copper core flexible wire, one end shall be connected to the grounding mark of the capacitor cabinet of the welding machine and the body, and the other end shall be connected to the grounding wire of the workshop or power supply system.

4. When installing in combination with welding tooling, attention must be paid to the insulation between the tooling and the body.

5. Compressed air pipe: After thoroughly removing the chips and dust on the pipe, connect the air inlet hose to the air inlet joint of the air source processor of the welding machine reliably. When the air supply switch is turned on and the air pressure is adjusted to 0.8Mpa, there shall be no leakage. Please use a rubber tube for air with pressure above 1.0Mpa.

6, cooling water piping: connect the hose for water supply and drainage to the water supply port and the drain port on the side of the machine body, and the connection shall be reliable and no leakage shall be allowed when the pressure is 0.3Mpa.