How to improve the work efficiency of spot welding machine?

1. Check whether there is dirt on the surface of the workpiece before welding. If a certain degree of oxide layer and oil rust accumulate, the solder joint will not meet the standard. (Can be pickled, sandblasted, oxide film removal, not pickled workpiece is not suitable for welding). Before operation, check whether all transmission, connection, lubrication and other parts and protective devices of the equipment are in good condition.

3. Discharge cooling water regularly to ensure the normal operation of the cooling system of the intermediate frequency welding machine.

4. Keep the machine clean and check the contact and insulation of each part. Cut off the power supply and stop the supply of compressed air and cooling water after use.

5. When the motor is repaired and the coil is replaced, the stator and rotor coil can be dried and drained with low voltage and high current of the pneumatic spot welding machine to replace the drying box.

6. Pay attention to the condition of the equipment during use. During normal use, the equipment will emit stable exhaust, press down and discharge sounds. If the machine runs slowly, slowly and abnormally, the power supply should be cut off for investigation.

7. Adjust the appropriate welding parameters according to the wave welding workpiece. The welding current should not be too large or too small. Inappropriate welding current will increase the probability of solder joint defects.