Reasons Affecting the Use Efficiency of Medium Frequency Spot Welding Machine

Intermediate Frequency Spot Welding Machine Controller The original solder resist controller was controlled by an electronic tube. After decades, it became a transistor, but some were still cumbersome and inconvenient. With the advancement of science and technology. In the past ten years, there have been microcomputer controllers, that is, CPU-centric controllers. Resistance spot welding machine controller is the implementation of the welding process control, monitoring and testing.

Next, let's look at the reasons that affect the use efficiency of intermediate frequency spot welding machines!

First of all, the perfect combination of heat and pressure and time is very important to the welding effect of the spot welding machine. Therefore, the temperature spread by the spot welding machine at each moment during the welding process should be just right. According to the size of the welded raw material, if the pressure is slow, it will partially heat up, thus weakening the welding effect of the spot welding machine.

In addition, if the current is suddenly stopped, cracks and raw material embrittlement will also occur in the quenching part of the welding machine.

Secondly, the power-on time will also affect the welding effect of the spot welding machine. Because the heat generated by the power-on is released through conduction, the power-on time is different, the heat received at the welding place (I. e. the highest temperature) is different, and the welding effect is different.

The above is the introduction of the relevant content of Sturt Technology on the reasons that affect the use efficiency of intermediate frequency spot welding machines. I hope it will be helpful to everyone.